Steren COM-817 Manual De Instrucciones página 53

2.3. Hardware Installation Procedures
To set up the COM-817 Repeater please refer to the following picture:
Attach one end of an Ethernet cable to your computer's Ethernet port, and
the other end to one of the LAN ports of your repeater.
Connect another Ethernet cable from your Cable/DSL modem to the WAN
port of your repeater.
Connect the single DC output connector of the power adapter to the power
jack on the back of the repeater and plug the Power Adapter into an AC
8 8
1 2 3 4 WAN WLAN SYS
POWER WPS