- Authentications type: The default is set to "Auto", which allows "Open
System" or "Shared Key" authentication to be used. Select "Shared Key" if
you only want to use "Shared Key" authentication (the sender and recipient
use a WEP key for authentication).
- Beacon Interval: The interval time of this COM-817 Repeater broadcast a
beacon. Beacon is used to synchronize the wireless
interval is 20-1000, the default is 100.
- RTS Threshold: You can set RTS Threshold value in this field, the valid
range should be 256-2347 and default value is 2347. If a network packet is
smaller than the preset RTS threshold size, the RTS/CTS mechanism will
not be enabled.
- Aggregation: You can accelerate the wireless transmission speed by
enabling the aggregation function. The default is AMPDU AMSDU.
- Fragmentation Threshold: It specifies the maximum size of packet during
the fragmentation of data to be transmitted.
- Transmission Rate: Transmit rate indicates the transmission speed of
wireless LAN access. The default setting is "Auto" and you can set this value
between 1-54Mbps range.
- ShortGi: You can select "Enable" or "disable".
- Protection: Using 802.11b and 802.11g mixed mode may result in poor
network performance. By enabling 802.11 protection, it will ameliorate
performance of 802.11g devices in your wireless network.
- Preamble Type: "Short Preamble" is suitable for heavy traffic wireless
network. "Long Preamble" provides much communication reliability; the
default setting is "Long Preamble".
network. The valid
31
31