Steren COM-817 Manual De Instrucciones página 74

- WDS Name: Give a description of your wireless bridge.
- WDS MAC Address: If the current working mode is "WDS" or "AP+WDS",
then you need to configure wireless bridge configuration. Enter MAC address
of remote access point, at the same time the remote access point also need
to configure to "WDS" or "AP+WDS" mode.
- Current WDS Information: It illustrates basic information of all wireless
bridge that in connection status, you may delete unnecessary bridge.
AP1:
- Select radio mode is WDS or AP+WDS in wireless management-basic of
AP1.
- Click on 'Wireless Management'- 'AP Setup'- 'Security' and select and save
None as authentication type.
- Click on 'Wireless Management'- 'AP Setup'- 'Security' and select and save
None as WDS authentication type or select a WDS security type, enter key
and save.
- Input WDS name (e.g.: default), input MAC address of AP2 (00-22-4f-bc-
af-5d), click add, then the record named default will appears in WDS list.
- Select channel is 'Channel 6' in wireless management-basic of AP2.
AP2:
- Selected radio mode must be WDS or AP+WDS in wireless
management-basic of AP2.
- The AP2IP address should be 192.168.1.x (1<x<255,e.g.: x=8).
- Select 'LAN setup'-'DHCP server', select disable DHCP server.
- Input WDS name (e.g.: Default), input MAC address of AP1 (00-22-4f-cc-
ae-f5), click add, then the Default name will appear in WDS list.
- Select 'Channel 6'in basic wireless management of AP2.
Note: Before you setup WDS connection, please make sure that AP1 and
AP2 is in the same network, that is if the IP address of AP1 is 192.168.1.1,
then the IP address of AP2 should be 192.168.1.x (1<x<255,e.g.: x=8).
29 29