Steren COM-817 Manual De Instrucciones página 75

4.5.4.2 Repeater Settings
Wireless Repeater mode is used to send the wireless signal from a net point
to the next and amplify it and form a new wireless coverage area.
AP1:
- Select radio mode is 'Access Point' in wireless management-basic of AP1.
- Select Channel is 'Channel 6' in wireless management-basic of AP1.
AP2:
- Select REPEATER'radio mode 'in wireless management-basic of AP2.
- Select Repeater SSID is 'Netis1' in wireless management-basic of AP2.
- Select Channel is 'Channel 6'in wireless management-basic of AP2.
- The IP address of AP2 should be 192.168.1.x (1<x<255,e.g.: x=8).
- Select 'LAN setup'-'DHCP server', select disable DHCP server.
AP3:
- Select radio mode is 'REPEATER' in wireless management-basic of AP3.
- Repeater SSID is 'Netis2'in wireless management-basic of AP2.
- Select Channel is 'Channel 6' in wireless management-basic of AP2.
- The IP address of AP3 should be 192.168.1.x (1<x<255),but different from
AP2.
- Select 'LAN setup'-'DHCP server', select disable DHCP server.
4.5.5. Wireless Advanced
These settings are only for more technically advanced users who have a
sufficient knowledge about wireless LAN. These settings should not be
changed unless you know what effect the change will have on your AP.
30 30