Steren COM-817 Manual De Instrucciones página 57

7. Press OK to close the Local Area
Connection Properties window.
3.2. Checking Connection to Repeater
After configuring the TCP/IP protocol, use the ping command to verify if the
computer can communicate with the Repeater. To execute the ping com-
mand, open the DOS window and Ping the IP address of the 300Mbps Wire-
less-N Broadband Repeater at the DOS prompt:
For Windows 98/Me: Start → Run. Type command and click OK.
For Windows 2000/XP: Start → Run. Type cmd and click OK.
For Windows 7 Start → Accessories → Command Prompt
At the DOS prompt, type the following command: ping 192.168.1.1
12 12