Adding/Removing An Rts Sun Sensor; Modifying The End Limits - SOMFY Oximo 40 Manual Del Usuario

8.3 Adding/Removing an RTS Sun sensor

Caution! no more than 3 sensors can be programmed in an
Oximo 40 WireFree™ RTS.
The procedure for adding or removing a Sun sensor is the
same.
- Check that the favourite position has been activated
(see section 6.5). This enables the sensor to be used
correctly.
- Access the battery's PROG button
1) Press and hold the battery PROG button until the roller
shutter moves for a few seconds:
The motor is in programming mode for approxima-
tely 2 minutes.
2) Briefly press the PROG button on the RTS Sun sensor
(O) to be added or removed:
The roller shutter moves up and down,
The RTS Sun sensor (O) is programmed or remo-
ved from the motor.
For the use of the RTS Sun sensor, refer to the RTS Sun
sensor guide.

8.4 Modifying the end limits

Adjusting and modifying the end limits depends on the type
of connections and bolts used and whether or not there are
stops on the end slat.
8.4.1 With locking straps and stops on the end slat
When the roller shutter is fitted with locking straps and
stops on the end slat, the end limits are readjusted every 56
cycles, or after the power supply has been cut off.
8.4.2 With locking straps and without stops on the end
slat
If the roller shutter is fitted with locking straps and without
stops on the end slat, the upper end limit can be modified.
Readjusting the upper end limit
1) Raise the roller shutter to the set upper end limit
position.
2) Press the Up and Down buttons until the roller shutter
moves up and down.
3) Adjust the upper position of the roller shutter using the Up
or Down buttons.
4) Press the STOP/my button until the roller shutter moves
up and down:
The new upper end limit position has been
programmed.
8.4.3 With flexible straps and stops on the end slat
If the roller shutter is fitted with flexible straps and stops on the
end slat, the upper end limit is automatically adjusted whereas
the lower end limit may be modified.
Readjusting the lower end limit
1) Lower the roller shutter to the set lower end limit position.
2) Press the Up and Down buttons until the roller shutter
moves up and down.
Copyright © 2009 Somfy SAS. All rights reserved.
.
Oximo 40 WireFree™ RTS
Adding
1 2
PROG.
Removing
O
1 2
PROG.
1 2
3 4
or
1 2
O
PROG.
O
O
PROG.
O
39