Use And Operating Mode; With An Rts Control Point; Obstacle Detection; Anti-Freeze Protection - SOMFY Oximo 40 Manual Del Usuario

Oximo 40 WireFree™ RTS
To activate or deactivate the motor:
1) Remove the battery's plastic cover on the cable side to
access the PROG button.
2) Press the battery's PROG button for a maximum of 1
second, then release it.
a) If the roller shutter moves in one direction then a
second later moves in the other direction:
The battery has deactivated the motor: the roller
shutter does not move, whatever signals are sent by
the control points or associated sensors.
b) If the roller shutter moves up and down briefly.
The battery has activated the motor: the roller shutter
moves according to the signals sent by the control
points or associated sensors.
3) Refit the battery's plastic cover.
Note:after installing the roller shutter, check that the motor is
activated using the RTS control point.

7. Use and operating mode

7.1 With an RTS control point

Caution! The motor will not respond to commands from a
Telis Modulis thumbwheel.
7.1.1 Favourite position ("my")
- Briefly press the STOP/my button:
The roller shutter starts to move and stops in the
favourite position (my).
If the roller shutter remains in initial position, the favourite
position has not been activated: see section 6.5.
7.1.2 Up / Down buttons
- Briefly press the Up or Down button to raise or lower the
roller shutter completely.
7.1.3 STOP function
The roller shutter is moving
- Press the STOP/my button:
The roller shutter stops automatically.

7.2 Obstacle detection

The automatic obstacle detection function protects the roller
shutter and enables obstacles to be cleared:
- If the roller shutter detects an obstacle when it is being
lowered:
Either the roller shutter stops automatically.
Or it stops and is automatically raised.
- If the roller shutter detects an obstacle when it is being
raised:
The roller shutter stops automatically.

7.3 Anti-freeze protection

The anti-freeze protection function operates in the same
way as the obstacle detection function:
- If the motor detects resistance:
It stops automatically to protect the roller shutter and
returns it to the initial position.
36
1
2
PROG.
< 1 sec.
a
1 sec.
or
b
my
Copyright © 2009 Somfy SAS. All rights reserved.
my