Wiring; With 1 Solar Panel; With 2 Solar Panels - SOMFY Oximo 40 Manual Del Usuario

Oximo 40 WireFree™ RTS
4.5.3 Motor/tube assembly
1) Slide the motor into the roller tube.
For smooth roller tubes, position the notch previously cut
on the crown.
2) Attach the roller tube to the drive wheel with three steel
pop rivets Ø 4 mm placed at:
- at least 5 mm from the far end of the drive wheel:
L1 - 5, and
- no more than 15 mm from the far end of the drive
wheel.
Caution! The pop rivets must only be attached to the drive
wheel and not to the motor.
4.5.4 Fitting the motorised tube
- Fit the tube/motor assembly to the end bracket (C).
- Fit the tube/motor assembly to the motor bracket (D).
Caution! Always make a loop in the power supply cable to
prevent water from entering the motor!

5. Wiring

Caution! The cables and connectors must be protected from
the roller shutter movement.
Somfy recommends placing the connectors behind the end
piece and fixing the cables inside the roller shutter casing.

5.1 With 1 solar panel

1) Wire the 2-pin connector of the solar panel to the battery
connector (E).
2) Wire the 4-pin connector of the Oximo 40 DC RTS motor
to the battery connector (F).

5.2 With 2 solar panels

1) Wire each solar panel to a connector on the Y splitter
cable (G).
See manual for Oximo WireFree™ Solar Panel.
2) Wire the 2-pin connector of the Y splitter cable (H) to the
battery connector (E).
3) Wire the 4-pin connector of the Oximo 40 DC RTS motor
to the battery connector (F).
32
1
2 15 mm
D
1
E
2
F
1
G
H
2
E
3
F
Copyright © 2009 Somfy SAS. All rights reserved.
5 mm
L1 20 mm
C
G
H