Installation; Installation Recommendations; Charging The Battery For The First Time; Installing The Solar Panel(S) - SOMFY Oximo 40 Manual Del Usuario

4. Installation

4.1 Installation recommendations

4.1.1 Motor location and distances to observe
The three components that make up the Oximo 40
WireFree™ RTS kit must be installed on the same side as
the roller shutter.
Somfy recommends that all components be fitted systemati-
cally to the left of the roller shutter, even when fitting a solar
panel. If it proves necessary to fit a second solar panel, it
would no longer be possible if the components are fitted on
the right hand side of the roller shutter.
- Minimum distance to be kept between two RTS motors:
20 cm.
- Minimum distance to be kept between the Oximo 40 DC
RTS motor and an RTS control point: 30 cm.
4.1.2 Location of the solar panel(s)
See manual for Oximo WireFree™ Solar Panel.
4.1.3 Battery location
See manual for Oximo WireFree™ Battery.
4.2 Charging the battery for the first time
See manual for Oximo WireFree™ Battery.

4.3 Installing the solar panel(s)

See manual for Oximo WireFree™ Solar™ Panel.

4.4 Installing the battery

See manual for Oximo WireFree™ Battery.

4.5 Installing the motor

4.5.1 Preparing the motor
1) Fit the crown (A) and the drive wheel (B) to the motor.
2) Measure the length (L1) between the motor head and
the end of the drive wheel.
4.5.2 Preparing the tube
Caution! Do not use octo 40 tube with inner clip.
1) Cut the roller tube to the required length.
2) Deburr the roller tube and remove the swarf.
3) For smooth roller
the following measurements:
- e = 5.5 mm
- h = 8 mm
Copyright © 2009 Somfy SAS. All rights reserved.
tubes, cut a notch
Oximo 40 WireFree™ RTS
1
A
2
L1 = ...
1
with
3
B
L1
2
Ø > 37
h
e
31