CASUALPLAY Multiprotector Fix Instrucciones página 23

Then press either the right or left side button (
•
pull the connector bar outwards (fig.10)
Locate the ISOFIX fasteners and line the MULTIPROTECTOR FIX up with
•
them (fig.11-12).Press the safety seat with both hands towards the fasteners
until a click indicates that both sides have been fastened correctly (fig.13).
Make sure that the system has been installed correctly by checking that there
•
is a green line on the top part of the connector release devices (fig.14). If
one of the connectors displays a red signal this means that it is not fastened
correctly, complete the operation again.
Lastly, adjust the space between the MULTIPROTECTOR FIX and the
•
backrest of the vehicle by pressing either of the two side buttons on the
base, and pushing it firmly against the backrest (fig.15).
Adjusting the height of the backrest
The MULTIPROTECTOR FIX, is height adjustable so it adapts to the child's
•
growth (fig.16). Once it is installed in the car with the child, adjust the height
of the MULTIPROTECTOR FIX. The seat belt should never go across the
child's neck.
Press the upper button and pull to adjust the height of the headrest
•
(fig.17).
WARNINg: For Group 1 place the headrest of the backrest in its lowest
position.
Adjusting the base of MULTIPROTECTOR FIX
The base is adjustable to adapt to the child's growth.
•
While the child is seated, adjust the base to suit the length of his legs.
•
Turn the position selector on the front dial to the left (
•
to adjust the length of the base so that it adapts to the child's legs. (fig.19)
Adjusting the reclining position of the MULTIPROTECTOR FIX
The position of the backrest can be adjusted. If the child is sleeping or want
•
to be in a more relaxed position, recline the backrest.
Turn the front position selector to the right (
•
the reclining position of the backrest as required (fig.21).
fig.9) and keeping it pressed
fig.18) and turn the dial
fig.20) and use the dial to adjust
21