CASUALPLAY Multiprotector Fix Instrucciones página 25

Removing the MULTIPROTECTOR FIX from the car (group 1)
Unfasten the vehicle seat belt.
•
Pass the seat belt through the guides on the Impact Shield and remove it.
•
If the fix connectors have been used to fasten the child restraint system to
•
the vehicle seat, disconnect them by pulling the buttons on both sides of the
release devices. If done correctly, a red signal will appear (fig.31).
Take the MULTIPROTECTOR FIX off the vehicle seat.
•
WARNINg: Remove and store the Impact Shield and the headrest adaptor.
Removing the headrest adaptor
Release the two elastic strips of the belt guide on the headrest.
•
Remove the headrest adaptor situated between the backrest of the
•
MULTIPROTECTOR FIX and the upholstery.
Installing the MULTIPROTECTOR FIX in the car
Pass the diagonal part of the seat belt through the belt guide found on the
•
headrest, to do this place it in its highest position (fig.32). Put the headrest
back to the appropriate position for the child's height.
Fasten the seat belt passing it over the MULTIPROTECTOR FIX so that the
•
abdominal part is as low as possible and the diagonal part holds the child's
trunk secure (fig.33).
Fasten the seat belt making sure that the abdominal part goes underneath
•
both armrests (zone marked in red) and that the diagonal part on the side of
the buckle goes over the top of it (fig.34). Adjust the height of the headrest
so that the car seat belt goes over the child's chest and not across his
neck.
gROUP 2–3 (from 15 to 36kg)
23