Remote Control - Revell Control Lateralis Manual Del Usuario

1 helICOPTer
1A Paddle rod
1B Counter-rotating
rotor blades
1C Headlamp
1D Landing skid
3 INSerTINg BaTTerIeS (reMOTe CONTrOl)
3A Unscrew the battery
compartment cover
and slide it down-
ward.
Attention: The battery and motor must cool down for 10 to 15 minutes before
charging and after every flight. Otherwise they can be damaged. The charging process
must be constantly monitored. Always ensure that the charging process takes place on
a fireproof surface in a fire-resistant environment.
1. Switch off the helicopter and the remote control.
2. Carefully insert the charging cable in the charge socket of the helicopter (4A).
The plug must be gently inserted into the charging socket – DO NOT USE FORCE.
If the plug is not correctly inserted into the charging socket, the helicopter may
become damaged and, under certain circumstances, become an injury risk.
3. Insert the USB plug into the open USB port on the remote control (4B).
4. Switch on the remote control, the power LED blinks red. Move the thrust control to
full throttle and back to zero; the power LED continuously illuminates red (4C).
5. The charging process is complete as soon as the power LED goes out.
6. After the charging process, switch the power switch to "OFF" and disconnect the
charge cable from the helicopter and the remote control.
16
1E Battery
1F Charge socket
1G ON/OFF
switch
3B Insert 6 AA batteries.
Please pay attention
to the polarity.
4 ChargINg The helICOPTer

2 reMOTe CONTrOl

2A Power LED
2B Controller for
forward/backward
flight and banking
2C Left/right trim
wheel
2D Power ON/OFF
3C Push the battery cover back
up and secure with the
screw.
2E Thrust and rotation
controller
2F Turbo switch for
greater flying speed
2G USB Port