Toto MS604114CEF Instrucciones De Instalación página 4

TOILET TANK FILL VALVE INSTRUCTIONS
G-Max™ / E-Max™ /Power Gravity
®
WARNING! DO NOT USE IN-TANK BOWL CLEANERS
The use of high concentration of chlorine or chlorine-related products can
seriously damage fittings in the tank. This damage can cause leakage and
property damage. TOTO  shall not be responsible or liable for any tank
fitting failure or damage caused by the use of in-tank bowl cleaners.
INSTALLATION
1. Shut OFF water supply to toilet.
2. Flush toilet and remove remaining water from tank with a sponge.
3. Remove the water supply connection at the fill valve.
4. Remove old fill valve and use damp sponge to clean hole in tank.
5. Place new fill valve inside tank hole.
6. Thread mounting nut onto fill valve shank and tighten nut.
Note: DO NOT OVERTIGHTEN. Be sure to install fill valve in a
position that does not interfer with the trip lever operation.
7. Connect water supply to fill valve shank and hand tighten only.
Note: DO NOT OVERTIGHTEN. These are plastic parts.
Never use pipe dope on any water supply connection.
8. Attach refill tube to fill valve nipple and clip other end of refill
tube to the overflow pipe.
9. Turn water supply ON and check for leaks outside the tank.
Note: As water fills the tank, water is also directed into the
overflow tube via the refill tube. This additional flow
of water is critical to refilling your toilet bowl. Once the
water stops filling the tank, some residual drops of water
may drip from the fill valve. This is NORMAL as these
drops will subside.
WATER LEVEL ADJUSTMENT
Depending on the manufacturing plant, you may have one
of two of the following fill valves.
WATER
LEVEL
Type A Type B
TOTO U.S.A., Inc.
• 1155 Southern Rd, Morrow, GA 30260 Tel. (888) 295-8134 • Fax (800) 699-4889

www.totousa.com Printed in U.S.A. TOTO LTD.
For Type A fill valve, refer to water level (WL) setting marked
on the inner wall of the tank. Allow the water to fill the tank
Turn the adjustment screw clockwise in the (+) direction to
increase the water level height. Turn the adjustment screw
counter-clockwise in the (-) direction to decrease the water
level height. Flush the toilet to verify the correct water level.
Adjust as necessary.
Top of
Overflow Tube
WL
For Type B fill valve, there are no water level adjustments.
THE FILL VALVE HAS BEEN PRESET AT THE FACTORY.
Top of
Overflow Tube
1/2"
(12mm)
OPERATION (NOTE TO OWNER)
You have chosen a TOTO product that is superior in quality

and craftsmanship. Our toilet flushing systems are the
best in the industry. To insure that your toilet is performing
correctly, always flush the toilet with a full stroke of the
trip lever to activate the flushing cycle. A full stroke will
guarantee that you are flushing with the power of a TOTO
If you need advice on your installation, feel free to contact
one of our Technical Support members at the number below.
©
REV 02/08
0GU013Z-5
M
IMPORTANT
Lisez attentivement ces instructions avant de
procéder à l'installation.
Vous avez fait l'acquisition de l'une des meilleures
toilettes actuellement disponibles, garantie par la
très bonne réputation dont béné cie TOTO
le monde entier.
Laisser ces instructions au client car elles
comportent des informations relatives à l'entretien
et à la garantie.
OUTILS DE BASE NÉCESSAIRES :
• Clé à molette 10''
• Niveau à bulle
• Mètre
• Pinces
• Tournevis
• Couteau à mastic
• Scie à métaux
.

MATÉRIEL NÉCESSAIRE :
• Tuyau / connecteur d'alimentation
• Robinet d'arrêt d'alimentation
• Boulons de support (2)
• Anneau / joint en cire
ANUEL D'INSTALLATION
ANUEL D'INSTALLATION
Pour toilettes une piece
Model
MS604114CEF(G) 28-1/8
MS853113(E)(S) 26-1/2
MS854114(E)(S)
MS854114SL 28-1/8
MS854114EL 28-1/8
MS86 3113(E) 26-1/2
MS864114(E)
MS864114L 28-1/8
MS866114 28-3/8
MS924154F 28-3/8
Toutes les dimensions sont indiquées en
pouces.
® dans
*
Remarque : Due à la puissante performance de nos systèmes de chasse d`eau G-max et Power Gravity
TM
qui ne sont pas spécifiés pour une installation Dos-à-dos. La seule façon d`installer ces WC
Dos-à-dos, est lorsque l`égout de connexion du cabinet inclus un élément WYE. Prendre soin de
contacter votre constructeur ou l`entrepreneur avant toute installation.
16-1/8 16-1/2
28-3/4
14-5/8 16-1/2
27-1/8
28 14-5/8 16-1/2
27-1/8
16-1/2 16-1/2 29 -1/8
16-1/2 16-1/2 29 -1/8
14-5/8 16-1/2 23-1/2
28 14-5/8 16-1/2 23-1/2
16-1/2 16-1/2 25-1/2
14-5/8 17-1/4
24-5/8
16-1/8 18-3/8 27-3/8
*Suggested Dimension
*
,
TM