Broan Best IS502 Manual Del Usuario página 4

OPERATION
Controls
The hood is operated using the (5) push-but-
tons located at eye-level, on the front edge of
the hood. Fig. 1.
The light button turns the halogen lights on
and off.
The blower on-off / speed 1 switch turns the
blower on to its lowest running speed. Press-
ing this switch a second time sets a TIMER
which keeps the blower operating at this
speed for 5 minutes. The corresponding LED
comes on during this time and the blower will shut off automatically. To turn OFF
the blower, push in and hold this blower switch for approximately 1 second.
The blower speed 2 switch turns the blower on to medium-low running speed.
Pressing this switch a second time sets a TIMER which keeps the blower operat-
ing at this speed for 5 minutes. The corresponding LED comes on during this time
and the blower will shut off automatically.
The blower speed 3 and blower speed 4 switches operate the same as blower
speed 2 switch except: Blower speed 3 is medium-high and blower speed 4 is
high.
After every 30 hours of operation, the LED of the "light button" comes on for 30
seconds after turning off the blower. This is a reminder to clean the grease filter.
Once the grease filter is cleaned and installed, press in and hold the "light button"
for approximately 1 second while the LED is on.
HALOGEN BULBS
This range hood requires
bulbs (Type T4, 12V, 20W).
ALWAYS SWITCH OFF THE ELECTRICITY
SUPPLY BEFORE CARRYING OUT ANY
OPERATIONS ON THE APPLIANCE.
NOTE: Avoid touching metal objects.
Doing so will cause fuse to open and
lamp operation failure. See page 5
for fuse replacement instructions.
To change bulbs:
1. Unscrew the mounting screws and take off
the lamp to handle more easily. Fig. 2.
2. Open the cover by prying from the proper
slots. - DO NOT ROTATE. CAUTION: BULB
MAY BE HOT! Fig. 3.
3. Replace with a bulb of the same type (T4,
12V, 20W). Do not touch replacement bulb
with bare hands!
two (2) halogen
- 4 -
BLOWER
SPEED 4
BLOWER
SPEED 3
BLOWER
SPEED 2
BLOWER
ON-OFF /
SPEED 1
LIGHT
BUTTON
MOUNTING SCREW
FIG. 1
FIG. 2
FIG. 3