Broan Best IS502 Manual Del Usuario página 9

5. Secure the Electrical System Plate to
the Blower Support with (3) sheet
metal screws. Fig. 12.
6. Position the bottom of the lower deco-
rative flue near the electrical system
plate. Fig.13.
7. Assemble the switch to the mounting
brackets located inside the lower
decorative flue. Make sure switch
buttons align with holes in the flue,
then secure with (2) sheet metal
screws. Fig. 13.
SUPPORT
FRAME
SWITCHES
SHEET METAL
SCREWS
8. Run lamp cables to the oval holes
located on both sides of the lower
decoative flue. Feed one wire through
each of the oval holes and tape each
to the outside of the flue. Fig. 13.
9. With the switch aligned with the sup-
port frame edge marked "FRONT",
carefully lift the flue over the support
frame. Fig. 14.
10. Lower the flue into position. Tuck
ELECTRICAL
SYSTEM
excess cable length inside the flue
PLATE
as it's lowered into position. Fig.14.
BLOWER
SUPPORT
FRONT
EDGE
SWITCH
FIG. 12
SHEET
METAL
SCREWS
11. Remove the grease filter. Fasten the
lower decorative flue to the hood
using (3) sheet metal screws. Fig.14.
12. Reinstall the filter and secure with
(2) mounting screws. Fig.15.
POWER
CABLE
TAPE
SCREWS
FIG. 13
- 9 -
LOWER FLUE
FIG. 14
FILTER
FIG. 15