Using The Rotary Commander - Sony WX-C5000 Manual De Instrucciones

Using the rotary
commander
The rotary commander works by pressing
buttons and/or rotating controls.
You can control an optional CD/MD unit with
the rotary commander.
By pressing buttons
(the SOURCE and MODE buttons)
(SOURCE)
Each time you press (SOURCE), the
source changes as follows:
B Radio B CD
* If the corresponding optional equipment is
not connected, this item will not appear.
Pressing (MODE) changes the operation
in the following ways:
• Radio: FM1 t FM2 t AM1 t AM2 t FM1
• CD unit: CD1 t CD2* t ... t CD1
• MD unit*: MD1 t MD2 t ... t MD1
• Tape: tape transport direction
* If the corresponding optional equipment is
not connected, these items will not appear.
Tip
You can turn on this unit by pressing (SOURCE) on
the rotary commander.
14
(MODE)
B MD* B TAPE
By rotating the control
(the SEEK/AMS control)
Rotate the control momentarily and
release it to:
•Locate the beginnings of tracks on the
tape. Rotate and hold the control, then
release it to fast-wind the tape.
•Locate a specific track on a disc. Rotate
and hold the control until you locate the
specific point in a track, then release it to
start playback.
•Tune in stations automatically. Rotate and
hold the control to find a specific station.
By pushing in and rotating the
control (the PRESET/DISC control)
Push in and rotate the control to:
•Receive the stations memorised on the
number buttons.
•Change the disc*.
* When an optional CD/MD unit is connected.