Start The Stimulation - DJO CEFAR REHAB X2 Manual De Instrucciones

5. SELECT A PROGRAM (P1–P30)
Press the PROGRAM button
P+
backward until the program of your choice is shown on the display.
Note! When selecting a program the amplitude must be set to 00.0
mA for both channels.
For further information on the programs, see chapter PROGRAMS .

6. START THE STIMULATION

TENS
Press the INCREASE button
reach a comfortable level of stimulation. Press and hold the but-
ton to increase the amplitude continuously.
NMES
Press the INCREASE button
hold the button to increase the amplitude continuously.
Note! Both channels must be used for programs P5 and P17–P18.
Note! Always increase the amplitude cautiously!
See section SPECIAL INSTRUCTIONS for the following cases:
• Mixed frequency stimulation
• Intermittent stimulation + hand switch
• Intermittent stimulation with Active Rest
An automatically activated key lock prevents unintentional changes during treatment. The key lock is
activated if no button is pressed for 20 seconds. Press any of the DECREASE buttons
the key lock.
The treatment time is preset, but can be changed by using the timer function, see section TIMER.
7. STOP THE STIMULATION
You can stop the stimulation before the program time has elapsed by pressing the DECREASE button
until the amplitudes are 00.0 mA or by pressing the ON/OFF button
When the program is finished, remaining time "00:00" is flashing on the display.
The last used program is saved when the stimulator is turned off and then pre-selected the next time AUTO AUTO
P S
the stimulator is turned on.
The stimulator turns off after 5 minutes of inactivity to spare batteries.
AUTO AUTO AUTO AUTO
or to step forward or
S S
P+ P– P–
for each channel until you
AUTO AUTO
P S
for each channel until you get visible muscle contractions. Press and
AUTO AUTO
S
P
to deactivate
AUTO AUTO
S
P
.
AUTO AUTO
S
P
13