Custom Programs - DJO CEFAR REHAB X2 Manual De Instrucciones

CUSTOM PROGRAMS

With the CEFAR REHAB X2 it is possible to create and store three custom programs (P28–P30) for
patient-specific treatment. To create a custom program, follow the programming procedure below. To
22
use a custom program, follow the instructions in the section STEP-BY-STEP USE.
Programming
1. Press the ON/OFF button
2. Press the PROGRAM button
30 is shown on the display. Select one of these programs.
3. Press the PROGRAMMING/CONFIRMATION button
ming mode. (See the programming chart for the following steps.)
4. Level 1 (shown in the upper right corner of the display):
The first step in the programming procedure is to choose between:
• Continuous (C) stimulation
• Intermittent (I) stimulation
Press the INCREASE (or DECREASE) button
choice by pressing the PROGRAMMING/CONFIRMATION button
You are moved to the next stage in the programming procedure.
5. Level 2
For Continuous stimulation there are no choices at Level 2. You are moved directly to Level 3.
If you chose Intermittent stimulation on Level 1, you now have two choices:
• Simultaneous (SI) stimulation
• Alternating (Alt) stimulation
Press the INCREASE (or DECREASE) button
choice by pressing the PROGRAMMING/CONFIRMATION button
You are moved to the next stage in the programming procedure.
6. Level 3
The available stimulation types on this level depend on your previous choices.
Press the INCREASE (or DECREASE) button
nate on the display. The programming chart shows the parameter setting possibilities for each
stimulation type.
Continuous stimulation types:
• Conventional (C)
• Burst (B)
• Pulse width/duration modulation (PWM)
• Frequency modulation (FM)
Intermittent/Simultaneous stimulation types:
• Conventional (C)
• Frequency modulation (FM)
For Intermittent/Alternating stimulation your only choice is Conventional stimulation, which is not
to turn the stimulator on.
AUTO AUTO AUTO AUTO
or to step forward or backward until Program 28, 29 or
P+ P+ S S
P– P–
AUTO
AUTO AUTO
P
S
P
P
P
P
AUTO
for 2 seconds to enter the program-
S
to toggle between C and I. Confirm your
AUTO AUTO
.
S
P
AUTO AUTO
S
to toggle between SI and Alt. Confirm your
AUTO AUTO
.
P S
AUTO AUTO
S
to see the different stimulation types alter-
AUTO AUTO
S