DJO CEFAR REHAB X2 Manual De Instrucciones página 23

shown on the display. You are moved directly to the next stage in the programming procedure (see
step 7).
Press the PROGRAMMING/CONFIRMATION button
type and you are moved to the next stage in the programming procedure. In the following steps you
will set the parameters for the selected stimulation type.
7. A preset parameter value is shown on the screen, but you can change this value by pressing the
INCREASE (or DECREASE) button
programming chart.
8. Press the PROGRAMMING/CONFIRMATION button
moved to the next stage (if any) in the programming procedure.
9. Repeat step 7 and 8 until the parameter value in the last stage is set.
10. The programming procedure is finished and you will automatically exit the programming mode. The
new program is now selected and ready for use. The program is also stored in the stimulator for
future use.
A custom program can be changed by redoing the programming.
AUTO AUTO
to confirm your choice of stimulation
S
P
. The valid range for the parameter is shown in the
AUTO AUTO
to confirm your setting. You are now
S
P
AUTO AUTO
P S
23