Environmental Protection; Declaration Of Conformity - Worx WX548 Manual Del Usuario

Blade Removing
OPERATION
Pendulum Function
Safety On/Off Switch
NOTE: For safety reasons the
On/Off switch of the machine
cannot be locked; it must
remain pressed during the
entire operation.
Increasing or reducing the
pressure on the On/Off switch
enables stepless stroke-rate
control of the switched-on
machine.
Straight Cut and Curve Cut
Bevel Cut
Plunge Cut
WORKING HINTS FOR YOUR
JIGSAW
If your power tool becomes too hot, please run your
jigsaw no load for 2-3 minutes to cool the motor.
Avoid prolonged usage at very low speeds.
Always use a blade suited to the material and
material thickness to be cut. For tight curves it is best
to use a narrow saw blade. When sawing metal or
similar materials, apply coolant/lubricant alongside
the cutting line.
Always ensure the workpiece is firmly held or
clamped to prevent movement. Any movement of
the material may affect the quality of the cut. The
blade cuts on the upward stroke and may chip the
uppermost. Ensure your uppermost surface is a non-
visible surface when your work is finished.
For easier control, use low speed to start cutting and
then increase to correct speed.
In order to avoid operation malfunctions, do not saw
gypsum board from below or overhead.
The guide roller should occasionally be checked for
wear and lubricated with a drop of oil. If it is worn, it
must be replaced.
MAINTENANCE
Remove the Battery Pack from the tool before
carrying out any adjustment, servicing or
maintenance.
There are no user serviceable parts in your power
tool. Never use water or chemical cleaners to clean
your power tool. Wipe clean with a dry cloth. Always
store your power tool in a dry place. Keep the motor
ventilation slots clean. Keep all working controls free
of dust. Occasionally you may see sparks through
the ventilation slots. This is normal and will not
damage your power tool.
Lithium-Ion cordless jigsaw
ENVIRONMENTAL
See Fig. B2
PROTECTION
See Fig. C
Check with your Local Authority or retailer for
recycling advice.
See Fig. D
DECLARATION OF
CONFORMITY
We,
POSITEC Germany GmbH
See Fig. E1, E2
Konrad-Adenauer-Ufer 37
50668 Köln
See Fig. F , G
See Fig. H Declare that the product
Description WORX Cordless Jigsaw
Type WX548 WX548.9 (540-559-designation
of machinery, representative of Jigsaw)
Function Sawing various materials
Complies with the following Directives:
2006/42/EC,
2011/65/EU,
2014/30/EU
Standards conform to
EN 55014-1,
EN 55014-2,
EN 60745-1,
EN 60745-2-11
The person authorized to compile the technical file,
Name Russell Nicholson
Address Positec Power Tools (Europe) Ltd,
PO Box 6242 Newbury RG14 9LT UK
Suzhou 2016/03/17
Allen Ding
Deputy Chief Engineer,Testing & Certification
Waste electrical products should not
be disposed of with household waste.
Please recycle where facilities exist.
9
EN