Sauder 412321 Manual Del Usuario página 12

8 8
How to use the SAUDER TWIST-LOCK
1. Insert the dowel end of the FASTENER into the
hole of the adjoining part.
NOTE: The dowel end of the FASTENER must remain
fully inserted in the hole of the adjoining part while
locking the FASTENER.
2. Tighten the FASTENER with a Phillips screwdriver
as tight as possible.
Notched edge
F
Surface without TWIST-LOCK
Fasten a SHELF (E) to the RIGHT END (A). Tighten two TWIST-LOCK
Fasten the SMALL BACK (F) to the SHELF (E). Use two BLACK 1-7/8" FLAT HEAD SCREWS (II).
Page 12
®
FASTENER
Dowel end
E
t h
®
w i
K
O C
c e
r f a
T - L
S
E R
S u
I S
E N
T W
S T
F A
®
FASTENER
www.sauder.com/services
A
Apply extra pressure when
turning the screws to push
them through the holes.
BLACK 1-7/8" FLAT HEAD SCREW
(2 used in this step)
® FASTENERS.
II
412321