Sauder 412321 Manual Del Usuario página 8

4 4
Apply pressure with your hands as
you guide the MOLDINGS over
the SCREWS and onto the ENDS.
O
Shoulder
2nd
O
These edges
should be even.
Carefully flip the ENDS over.
Turn fourteen BLACK 9/16" FLAT HEAD SCREWS (KK) into the ENDS (A and B) until the shoulder of the SCREWS rest on the
surface of the END.
1. Slide the LOWER END MOLDING (R) onto the ENDS (A and B). Line up the groove in the MOLDINGS over the head of the
SCREWS in the MOLDINGS.
2. Slide the VERTICAL MOLDING (O) onto the ENDS (A and B) until is against the LOWER END MOLDINGS (R). Line up the
groove in the MOLDINGS over the head of the SCREWS in the MOLDINGS.
Page 8
Shoulder
2nd
O
B
R
1st
www.sauder.com/services
Apply pressure with your hands as
you guide the MOLDINGS over
the SCREWS and onto the ENDS.
R
A
BLACK 9/16" FLAT HEAD SCREW
(14 used in this step)
1st
These edges
should be even.
1st
R
KK
412321