Operation - Bosch MultiTalent 3 MCM3 Serie Instrucciones De Uso

Ocultar thumbs Ver también para MultiTalent 3 MCM3 Serie:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 89
en
Operation 

Operation

Before operating the appliance and accesso-
ries for the first time, clean thoroughly; see 
"Cleaning and servicing".
Preparation
  ■ Place the base unit on a smooth, clean 
surface.
  ■ Pull cable out of the base unit to the 
required length.
Important information
  – Use only the rotary switch to switch the 
appliance on or off.
  – Never switch the appliance off by rotating 
the bowl, the blender or a tool.
  – Do not switch the appliance on unless 
tools or accessories have been completely 
attached.
Bowl with accessories/tools
W Risk of injury from the rotating tools!
While the appliance is operating, never place 
fingers in the mixing bowl. Always use the 
pusher for adding ingredients. After switching 
off, the drive continues running for a short 
time. Change tools only when the drive is at 
a standstill.
Warning!
When working with the bowl, the appliance 
cannot be switched on until the bowl has 
been attached and the lid has been attached 
and screwed on tight.
Universal blade
for cutting, mincing, mixing.
W Risk of injury from sharp blades!
Do not touch blades of the universal blade 
with bare hands. When not in use, always 
store the universal blade in the blade guard. 
Grip the universal blade by the edge of the 
plastic handle only.
Kneading hook
for kneading dough and mixing-in 
ingredients that ought not be cut (e.g. raisins 
and chocolate chips).
Chopping disc
for cream, egg white and 
mayonnaise.
16 
Fig. B
  ■ Attach the bowl (arrow on bowl on dot 
on the appliance) and rotate as far as 
possible in a clockwise direction.
  ■ Insert tool holder into the bowl.
  ■ Insert universal blade, whisking disc or 
kneading hook into the tool holder and 
release. 
Note position of the tools when
inserting them! Press tools all the way
down.
Warning!
Do not add ingredients until the tools have 
been inserted.
  ■ Add ingredients.
  ■ Attach lid with pusher (match arrow on lid 
on dot on bowl) and rotate in a clockwise 
direction. Lid lug must be located fully in 
the slot in the bowl handle.
  ■ Insert the mains plug.
  ■ Set the rotary switch to the desired setting.
  ■ To add more ingredients, set the rotary 
switch to P.
  ■ Remove the pusher and add ingredients 
through the feed tube. Pusher can be used 
as a measuring cup.
Cutting discs
W Risk of injury from sharp blades!
Do not grip the sharp blades or edges of the 
cutting discs. Take hold of discs by the edge 
only! Do not place fingers in the feed tube. 
Only use the pusher when adding more 
ingredients.
Slicing reversible disc –
thick/thin
for slicing fruit and vegetables. 
Process at setting 1.
Identification on the reversible slicing disc: 
"grob" for the thick cutting side,  
"fein" for the thin cutting side
Warning!
The reversible slicing disc is not suitable for 
slicing hard cheese, bread, rolls or choco-
late. Slice boiled, waxy potatoes only when 
they are cold.

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Multitalent 3 mcm3200w

Tabla de contenido