Publicidad
Brake Control Wiring Harness
INSTALLATION INSTRUCTIONS
Note: This harness has been
designed for use with Valley™
brake controls containing a
pre-wired harness conector
(Fig. 1). For all other brake
controls, use Valley harness part number 30402.
1. Read instructions thoroughly before beginning.
2. Locate the vehicle's OEM brake control connector under
the dash, taped to another vehicle
harness near the emergency brake
pedal. The connector will be similar
to that found on the Brake Control
Wiring Harness and designed
to mate with it (Fig. 2). Refer to
the vehicles owners manual for
additional information in locating
this connector.
3. Connect the brake control
wiring harness to the brake control by plugging the
mating connectors together. Ensure that the locking tabs are
engaged (Fig. 3).
4. Plug the opposite end of the brake control wiring
harness into the vehicle's mating connector located during
Fig. 1
Fig. 2
Publicidad
