Residual Risk; Equipment Setup And Use; Prior To Use; Setup - AMATECH F-AHTR Instrucciones De Uso

INSTRUCTIONS FOR USE

2.6 Residual risk:

This product complies with relevant safety standards. However, Patient harm from
misuse hazards cannot be completely excluded.
3

Equipment Setup and Use:

3.1 Prior to use:

a. Inspect the product looking for any visible damage or sharp edges that could
be caused by a drop or impact during storage.
b. Make sure product has been properly cleaned and disinfected and wiped dry
prior to each use.

3.2 Setup:

a. Place the two rail clamps on the surgical table's back
section rail approximately 12", 30.5 cm, apart on the
patient's affected side.
b. Hold the table vertically above the rail clamps with
the frame braces outboard of the surgical table and
the Mounting Blades pointing toward the open slots
of the rail clamps.
c. Lower the blades into the clamps & tighten the rail
clamp locking knobs.
d. Fold the table down making sure that the frame
brace ends engage the brace openings in the
mounting blades.
e. To adjust height, loosen the rail clamp knobs. Grasp
the table top adjacent to the rail clamps and raise or
lower the table to the desired height. Securely
tighten the rail clamp knobs.
f. For F-AHTR: With the Table set at the surgeons working
height, loosen Leg Lock Handle at the ball socket
near end of table. Swing the leg down and slide ball
socket to position of least interference with surgeon,
C-arm, etc. Loosen Leg Extension Knob and adjust
leg length so the foot is securely against the floor.
Firmly lock both handles to stabilize table end.
Note: Support leg may be folded up out of the way for C-arm access only. Care
must be taken not to apply any additional loads beyond the patient's arm weight
while the support leg is not in contact with the floor.
Document Number:D-720062
Version: C
Page 12
Mounting
Blades
12" / 30.5 cm
Issue Date: 27 MAR 2020
Ref Blank Template: 80025118 Ver. E