Spout Installation - Kohler K-116 Guia De Instalacion

Apply plumbers
putty.
Putty Ring
(if included)

1. Spout Installation

Apply a bead of plumbers putty or other sealant to the underside
of the spout or putty ring (if supplied) according to the putty
manufacturer's instructions.
Locate the center hole and insert the spout.
NOTE: For a thin-walled lavatory (such as stainless steel), slide the
washer and nut onto the spout shank. Securely tighten the nut with
a wrench. Do not overtighten.
Slide the metal washer and nut onto the spout shank.
Position the metal washer so the second hole lines up with the
drain lift rod hole on the back of the spout.
Securely tighten the nut with a wrench. Do not overtighten.
Remove any excess putty or sealant.
Kohler Co.
Nut
Metal
Washer
3 1002628-2-M