Using The Pluto; Maintenance - Be Cool pluto Manual Del Usuario

EN
of the seat follow the same process in reverse.

3. USING THE PLUTO

Seal belt: from 15 kg-36 kg
2b. With the child in place in the seat put the seat
belt on passing it through the guide. Fasten the seat
belt buckle and make sure the belt is not too loose
by gently pulling the diagonal part of the belt before
placing the belt over the child's chest.
Seat extension system.
Once the child readies 18 kg (105 cm approx.) the seat
grows with him.
Press the lever (3) and pull the headrest upwards
5.
and the seat will extend to suit your child's height. The
harness will automatically move upwards without you
having to do anything.
Make sure that the belt guide is about 2 centimetres
32
above the child's shoulder.
2d. If you need to lower the position of the harness
move the upholstery of the headrest upwards and
press the lever to move the port marked push
downwards.

MAINTENANCE

Fitting / Removing the cover
It is very easy to take the cover off. The cover has 7
fastening points on the front part. Simply unfasten
these points and then gently pull the front part of
the cover.
On the sides of the seat there are some plastic parts
that are used to fasten the cover. Simply pull these
gently to take the cover off.
To put the cover bock on again just follow the same
process in reverse. Fit the parts into the slots for the
sides.