For Your Safety; Tool Specifications; Use As Intended - Würth master EH 4 Manual De Instrucciones

EH 4book Seite 10 Dienstag, 24. Januar 2006 11:50 11
GB
Working safely with this machine
is possible only when the operating
and safety information are read
completely and the instructions
contained therein are strictly fol-
lowed. In addition, the general safety notes in
the enclosed booklet must be observed.
The machine must not be damp and
must also not be operated in damp
surroundings.
If the mains cable is damaged or cut
through while working, do not touch
the cable but immediately pull the
mains plug. Never use the machine
with a damaged cable.
Wear safety glasses, protective
gloves and sturdy shoes.
Dust developing during work can be harmful
to one's health, combustible or explosive. Sui-
table protective measures are required.
Do not reach into the chip ejector with your
hands. They could be injured by rotating parts.
Guide the machine against the workpiece only
when it is switched on. Otherwise there may be
danger of kickback when the tool insert jams in
the workpiece.

Tool Specifications

Electro-Planer
Order number
Rated power consumption
No-load speed
Planer length
Planer width
Chip depth
Rebate depth
Weight
Protection class
10

For Your Safety

For further notes on safety refer to the enclosed sheet
The machine is intended for the planing of wood
EH 4
materials such as beams and board while resting
0702 816 X
firmly on the workpiece. It is also suitable for struc-
1050 W turing with rustic cutter blades, for chamfering of
edges and rebating.
13500 rpm
For damage caused by usage other then intended,
320 mm
the user is responsible.
82 mm
4,0 mm
25 mm
4.0 kg
/II
When working, always hold the planer in
such a manner that the base plate faces flat on
the workpiece. Otherwise the planer can
become wedged and lead to injuries.
Never plane over metal objects, nails or
screws. The planer blade and the blade shaft
can become damaged and lead to increased
vibrations.
Wait for the blade shaft to stop before setting
the machine down. An exposed blade shaft
can seize with the surface, leading to possible
loss of control and serious injury.
Do not leave the chuck key inserted.
For long hair, wear hair protection. Work only
with close-fitting clothes.
When working with the machine, always hold
it firmly with both hands and provide for a
secure stance.
Keep mains lead clear from working range of
the machine. Always direct the cable to the rear
away from the machine.
Never allow children to use the machine.
Do not drill into housing or attach rivets in order
to mark the machine. The double insulation is
then no longer ensured. Use stickers.
Use only original Würth parts and accesso-
ries.

Use as intended