Maintenance And Cleaning; Noise/Vibration Information; Declaration Of Conformity - Würth master EH 4 Manual De Instrucciones

EH 4book Seite 13 Dienstag, 24. Januar 2006 11:50 11
For the flat planing of surfaces, it is recommended
that a small chip depth be set and the planing pass
be repeated several times.
Chamfering of Edges
Located in the middle of the front base plate of the
planer is a V-groove 12 that makes possible quick
and easy chamfering of workpiece edges.
For this purpose, place the V-groove of the planer on
the workpiece edge and guide along.
During the chamfering, take care to maintain a con-
stant position angle (45°) and uniform advancing.

Maintenance and Cleaning

Before any work on the machine itself, pull the
mains plug.
For safe and proper working, always keep the
machine and the ventilation slots clean.
If the machine should fail despite the care taken in
manufacturing and testing, repair should be carried
out by a Würth Master-Service agent.
In all correspondence and spare parts orders,
please always include the 8-digit order number
given on the nameplate of the machine.
For the current spare parts list of this machine, log into
the Internet under "http://www.wuerth.com/parts-
manager" or ask for a copy at your nearest Würth
branch office.
Disposal
Power tools, accessories and packaging should be
sorted for environmental-friendly recycling.
Only for EC countries:
Do not dispose of power tools into
household waste!
According to the European Directive
2002/96/EC on waste electrical
and electronic equipment and its
incorporation into national law, power tools that are
no longer suitable for use must be separately col-
lected and sent for recovery in an environmental-
friendly manner.
Würth will gladly take back your defective Würth
power tool free of charge.
For this Würth tool, we provide a warranty in
accordance with statutory /country-specific regula-
tions from the date of purchase (proof of purchase
by invoice or delivery note). Damage that has
occurred will be corrected by replacement or repair.
Damage caused by normal wear, overloading or
improper handling is excluded from the warranty.
Claims can be recognised only when the tool is pre-
sented undisassembled to a Würth branch office or
a Würth field service employee.

Noise/Vibration Information

Measured
EN 60 745.
Typically the A-weighted noise levels of the machine
are: Sound pressure level: 87,3 dB (A); Sound pow-
er level: 98,3 dB (A).
Wear hearing protection!
The typically weighted acceleration is 2,96 m/s

Declaration of Conformity

We declare under our sole responsibility that this
product is in conformity with the following standards
or standardization documents: EN 55014-1,
EN 55014-2, EN 61000-3-2, EN 61000-3-3,
EN 60745 according to the provisions of the regu-
lations 73/23/EEC, 89/336/EEC, 98/37/EC.
05
Adolf Würth GmbH & Co. KG
P. Zürn
Subject to change without notice
Warranty
values determined according
R. Bauer
to
2
.
13