Function Turning On The Unit - PRESIDENT RANDY III El Manual Del Propietario

6.
Press the s or t key (3) to select the genre or...
7. Press the MENU key (4) to confirm the genre. The code value
flashes (unless OFF selected).
8.
Press the s or t key (3) to select the code (from 01 to 38 for
CTCSS and 001 to 104 for DCS).
Different Mode DF
5. A short press on the MENU key (4) makes the type RX blink.
6. Press the s or t key (3) to select the RX or TX type.
7. A short press on the MENU key (4) validates the choice of type.
The genre value flashes ("CTCSS", "DCS" or "OFF" no genre).
8.
Press the s or t key (3) to select the genre or...
9. Press the MENU key (4) to confirm the genre. The code value
flashes (unless OFF has been selected).
10. Press the s or t key (3) to select the code (01 to 38 for CTCSS
001 to 104 for DCS).
11. Press the MENU key (4) to confirm the selected code. The unit
return to point 5, for set the second type.
12. If you don't need to set the second type, long press the MENU
key (4) to validate and exit the MENU.
13. If no key is pressed, the device exits the MENU after 10 seconds
without saving the changes.
The default mode is I d (Identical). The default genre is OFF.
See the RESET menu.
10) RESET
This function allows to restore all factory parameters.
1. Long press the MENU key (4) to enter the MENU.
the display.
2.
Press the s or t key (3) to select the
3. Short press the MENU key (4) to validate the menu.
4. Short press the MENU key (4) to validate the reset.
5.
The unit restarts with all the factory parameters.
F) FUNCTION TURNING ON THE UNIT
1) F - FREQUENCY BAND SELECTION
(Configuration: EU ; PL ; d ; EC ; U ; In)
The frequency bands must be chosen according to the country
where you are going to operate. Do not use another configu-
ration. Some countries require user's licence. See the table on
page 66.
menu.
21
appears on
blinks.