Beep Tone : On/Off; Scan Function; Frequency Band Selection - PRESIDENT TAYLOR III Manual Del Usuario

B/ Frequency Modulation (FM) is for nearby communications in flat, open
areas. It gives better quality of communication (squelch adjustment needs
more finesse).
6) 6-PIN MICROPHONE PLUG
This plug is situated on the front panel, thereby making it easier to set the
equipment into the dashboard. See the cabling diagram on page xxx.
7) UP AND DOWN KEYS
Both keys allow to go up and down the channels by a brief pressure. A con-
tinuous pressure allows to ascend five channels per second.

BEEP TONE : ON/OFF

Some functions like changing channels, pressure on keys etc. are confirmed
by a beep tone. This beep tone can be activated or deactivated by the user
by following this procedure :
a) Turn on the power while pressing the mic "UP" switch. Beep tone enable (On)
b) Turn on the power while pressing the mic "DN" switch. Beep tone disable (Off)

SCAN FUNCTION

In order to activate the SCAN function (research of the channels) in an
increasing way, press the UP key during 2,5 seconds. The scanning automati-
cally starts 3 seconds after the end of the transmission if no key is activated.
The scanning starts again in an increasing way by using the UP key of the
microphone or in a decreasing way with the DN key of the mike.
8) PTT (push to talk)
Depress this knob to transmit a message and release to listen to an incoming
communication.
TOT (Time Out Timer)
If the PTT key (8) is pressed for more than 5 minutes, the transmission ends until
the PTT key (8) is released.

FREQUENCY BAND SELECTION

(configuration: EU; PL; d; EC; U; In)
The frequency bands have to be chosen according to the country of use.
Don't use any other configuration. Some countries need a user's licence.
See table on page xxx.
Proceeding
a) Switch off the CB radio.
b) Press and hold the PTT button of the microphone and then switch on CB radio.
The letter corresponding to configuration is blinking.
c) To choose the configuration turn the channel selector rotary knob or use
buttons UP/DN of the microphone.
d) Press the PTT button of the microphone one second until the letter correspond-
ing to configuration stop blinking to confirm the configuration.
e) Switch the CB radio off in order to save.
See the configurations/ frequency bands table at pages xxx ~ xxx.
A) DC-POWER TERMINAL (13.2 V)
B) ANTENNA CONNECTOR (SO-239)
C) EXTERNAL SPEAKER JACK (8 Ω, Ø 3.5 mm)
27