Beha-Amprobe UAT-505-EUR Manual De Usuario página 11

Antenna Configurations
Peak signal with left/right arrows. This configuration is satisfactory for general
purpose locating.
Null signal with left/right arrows. This configuration gives a sharp Null signal over the
line but is less accurate than when in Peak Mode. Is useful for tracing long lines as
the sharp Null signal is easy to trace.
Using the Null Mode
To select Null Mode, switch the unit on and press "ENTER" to access the Settings Menu.
Select and exit the Settings Menu. The bar graph will now show a minimum signal over the line.
The left/right arrows will also indicate the position of the line.
999
8kHz
33kHz
50Hz
Radio
Note: Use the Null Mode with caution as it is not as accurate as Peak Mode. The Null Mode is useful in detecting
the approximate position of a line when tracing over a long distance.
100
999
8kHz
33kHz
50Hz
Radio
999
8kHz
33kHz
50Hz
Radio
7
100
999
8kHz
33kHz
50Hz
Radio