Torque Arm; Gearmotor Mounting Options; Gearbox Positions - HYTROL HSS Manual De Instalación Y Mantenimiento

• Torque Arm

1. Mount the torque arm to the gearmotor as close to level to the ground as
possible. (Figure 6A through 6F). Use the series of holes to mount the torque
arm by 10-15 degree increments.
2. Adjust the bushing mounting bracket up or down depending on the
necessary adjustment. (Figure 6G)
3. The gearmotor should be angled within 10 degrees of 0, preferably at
absolute 0.
4. Tighten all hardware to secure mounting.
FIGURE 6B

1.4764
10.1°
FIGURE 6D
15.1°
FIGURE 6F
15.1°

• Gearmotor Mounting Options

KT/SEW, NORD, Sumitomo
HARDWARE DEPENDENT
WA-047944-OAW ON BOX SIZE
(EL EQUIPO DE MONTAJE DEPENDE
DEL TAMAÑO DE LA CAJA)
KT47
KT67
KT87
TORQUE ARM MOUNTS
TO GEAR BOX
(EL BRAZO FIJO SE
MONTA EN LA CAJA DE
ENGRANAJES)
TORQUE ARM MOUNTS
FIGURE 6A
KT37
FIGURE 6C
KT57
FIGURE 6E
13.3°
FIGURE 6G
5.5° OF ADJUSTMENT UP & DOWN
TOTAL OF 11° POSSIBLE TRAVEL
(5.5° DE AJUSTE HACIA ARRIBA Y
HACIA ABAJO DEL DESPLAZAMIENTO
TOTAL POSIBLE DE 11°)

• Gearbox Positions

To change the position of the gearbox, unbolt the torque arm from the
gearbox, rotate the gearbox to the desired position, and rebolt it to the
corresponding holes.
FT TORQUE ARM
WA-047944-OAW
6
 1.2992
 1.6535
HARDWARE
DEPENDENT ON
BOX SIZE
13°
15.1°
KT77