Setting The Menu Items - Panasonic AW-HE100E Manual De Usuario

Setting the menu items

Setting the menu items
When the unit's settings are to be selected, the menus are
displayed on the monitor.
The monitor is connected to the video signal output
connector (VIDEO OUT connector or HD/SD ANALOG
connector).
The basic menu operations involve displaying sub-menus
from the main menu items, and selecting settings on the
sub-menus.
Some sub-menus have menu items for performing more
detailed settings.
For details on the basic operations to display the menus
and change the items using the accessory wireless remote
control or controller (AW-RP655, AW-RP555 or AW-RP400),
refer to pages 39 to 41.
Main menu
 HE100 menu 
Pan Tilt Head Setting
1--------
Camera Setting
2--------
1 Pan Tilt Head Setting menu display
2 Camera Setting menu display
Pan-tilt head unit setting menu
 Pan Tilt Head Setting 
Tally
3--------
Landing
4--------
Install Position
5--------
Smart Picture Flip
6--------
Flip Detect Angle
7----------
Controller
8--------
Initialize
9------
Return
------
3 Tally lamp use selection [Tally: On, Off]
4 Landing selection [Landing: Soft, Just]
5 Desktop (stand-alone) installation/
6 Automatic picture flipping selection
7 Tilt angle at which automatic picture flipping
8 Accept control from control device selection
On
Soft
Desktop
Auto
90
All
42 (E)
(Factory setting: On = controlled)
Using this item, set the function for having the tally lamp
lit or extinguished by the tally control signal to ON or OFF.
(Factory setting: Soft landing)
Using this item, select "Soft" or "Just" (exact) as the
landing characteristics.
The level of vibration accompanying the acceleration or
deceleration initiated by the stop operation is less at the
"Soft" setting than at the "Just" (exact) setting.
Hanging (suspended) installation selection
[Install Position: Desktop, Hanging]
(Factory setting: Desktop)
Using this item, select stand-alone (Desktop) or
suspension from an overhead surface (Hanging) as the
manner in which the unit is to be installed.
Desktop: Stand-alone installation
Hanging: Installation where the unit is suspended
from an overhead surface
[Smart Picture Flip: Auto, Off]
(Factory setting: Off = no flipping)
Using this item, select the function for flipping the picture
when tilting reaches the specified angle to ON or OFF.
starts [Flip Detect Angle: 60 to 120]
(Factory setting: 90°)
Using this item, select the tilt angle at which the picture is
flipped when "Auto" has been selected as the automatic
picture flipping selection [Smart Picture Flip] setting.
[Controller: All, RP, Option, RP/Option]
(Factory setting: All = All control devices)
All:
All control devices (Including accessory
wireless remote control)
RP:
Controller only
Option:
Expansion board only
RP/Option: Controller and expansion board
 At the point when this item's setting is changed, the
new setting is not reflected in operation.
It is reflected when the unit is set to the standby mode
and its power is turned on.