Publicidad
L O M O ' I N S T A N T W I D E S p l i t z e r
I N S T A L L I N G T H E S P L I T Z E R
Simply screw the Lomo'Instant Wide Splitzer onto the filter thread of the
Lomo'Instant Wide lens.
S T A R T T H E S P L I T Z E R M A G I C
The splitzing magic is done via two rotating blinds – thereby dividing
up the image frame in a countless variety of ways. Each of the
blinds has a small plastic nub that you can turn with a fingernail.
Once you have connected your Splitzer, press the MX Button once
to activate the MX Mode. When the MX Mode is turned on, the MX
Mode Indication Light above the MX Button will shine orange. Then
shoot to expose one side of your image, twist the Splitzer around
and then shoot again to expose the other side of the image. When
you have finished your last exposure, press the MX Button again to
eject the film.
C A R E A N D W A R R A N T Y
Please only clean the lens attachments with a proper lens solution and
a soft cloth. Never force the lens attachment on or off the camera as this
could cause damage to the attachment and to the camera body. When
not in use, please cover the attachments with the lens caps.
Your Lomo'Instant Wide Lens Attachments and Splitzer have a 2-year
warranty against any manufacturer defects. In the event of a defect, the
Lomographic Society will repair or replace the item at our discretion. For
the warranty service, please contact your closest Lomographic Office.
1 2 7
Publicidad
