Publicidad
A U T O O F F F U N C T I O N
When the Lomo'Instant Wide hasn't been operated for five minutes,
regardless of the shooting mode, it will switch off automatically to save
battery power. To re-activate the camera, simply press any button on the
Lomo'Instant Wide.
F L A S H O N / O F F B U T T O N
In all modes (except "Off"), the Flash is "On" by default. This means every
time you switch on your camera, the flash will automatically be "On". If
you want to shoot without the flash, press the Flash On/ Off Button
once and the built-in flash will be switched off until the camera is turned
off.
There is a Flash indication light
Green light on:
Red light on:
No light on:
P C - S Y N C
There is a PC-Sync Socket
to connect external flash with PC connection to your camera. To connect
external flash, simply plug the PC-Sync connection of your flash into the
PC-Sync Socket
With an external flash connected, there is no interference with the
built-in flash on the Lomo'Instant Wide. You can still set the internal
flash as "On" or "Off" as normal.
1 0
The Flash is fully charged and ready to shoot.
The Flash is recharging.
The Flash is off and the camera will automatically
expose according to ambient light in Auto Shooting
Mode.
on Lomo'Instant Wide which allows you
1 1
on Lomo'Instant Wide.
1 1
above the Flash On/Off Button
9
:
9
1 3
Publicidad
