Publicidad
T R O U B L E S H O O T I N G
Q
The camera is functioning but the film does not eject after the Shut-
ter Release Button
Please check the following:
A
• Make sure that there is film installed in the camera.
• Check the Film Counter Window 3
an end.
• Make sure that the proper shooting mode is enabled and ensure the
camera is not set to "Off".
• Check if the MX Mode Indication Light 1 7
is on. If it is, that means you are in the MX Mode. Press the MX But
ton
again to switch off the MX Mode.
1 6
• Check the battery power by checking the battery light inside the
Film Counter Window
camera is running out of battery. You should insert fresh batteries.
Q
The Auto exposure seems to be incorrect, my subject is under- or
overexposed.
Firstly check if anything is blocking the Light Sensor
A
Light Sensor
Shooting Mode. The ambient exposure value and auto flash output
may also be affected by a very bright or very dark background.
Set the Exposure Compensation Switch
if your image is too dark, or if your image is too bright, set the
Exposure Compensation Switch
C A R E A N D W A R R A N T Y
Your Lomo'Instant Wide has a 2-year warranty against any manufactur-
er defects. In the event of a defect, the Lomographic Society will repair
or replace the item at our discretion. For the warranty service, please
contact your closest Lomographic Office.
is pressed.
7
. If it is blinking green, that means your
3
, then check if the camera is correctly set to Auto
2 2
to see if your film has come to
above the MX Button
to "+1" and shoot again
1 4
to "-1".
1 4
1 6
and Flash
2 1
1 7
Publicidad
