Maintenance And Storage - Hudora 14936 Instrucciones De Montaje Y De Uso

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 9
INSTRUCTIONS ON aSSEMBLY aND USE
EN
USaGE INSTRUCTIONS
NOTHING'S EASY AT FIRST ...
... most accidents happen to "beginners" within the first ten minutes. Particular
care should be taken during this stage.
USAGE INSTRUCTIONS
The scooter moves when a foot is used to regularly push off, just as with well-
known children's scooters. Braking is no problem either - simply step on the
friction brake over the back wheel (mudguard).
We recommend folding the scooter by hand after each use. Aluminium is a good
and light material but should also be handled carefully as it is not as hard as
steel, for example.
SwITCHING ON THE EFFECTS
In order to use the sound, light and steam system, you need to insert four AA
batteries. The batteries are not included in the shipment. These batteries can
be purchased commercially anywhere. In order to insert the batteries, turn the
scooter so that you have good access to the battery panel beneath the footboard.
Loosen the screw of the battery cover and remove the cladding. You need a
Phillips screwdriver (not included in the shipment), to loosen the screw. Insert
the batteries or respectively replace them. You should thereby pay attention to
the correct polarity (Fig. 8). Screw the battery cladding firmly back on again.
Open the water tank, in order to refill the water, by pulling the rubber forwards
and up (fig. 9). The tank holds about 120 ml. Note: The lid of the water tank is
operationally not 100% leak-proof. Water can leak occasionally - in particular
during transport or in the case of slanted storage. Bear this in mind in order to
avoid water damage.
Press the On / Off button on the bottom side of the scooter, in order to put the
sound, light and steam system to into operation (Fig. 8). In order to turn on
the effects, the right handlebar grip has to be turned back to the driver. The
rotating handle can slightly loosen within the scope of use. You should in such a
case, sufficiently firmly tighten it again using an Allen key. (Fig. 10) Turn off the
effects, when the scooter is not in use.

MaINTENaNCE aND STORaGE

Use a dry or damp cloth only to clean the product; do not use special cleaning
agents! Check the product for damage or traces of wear and tear before and
after each use. Do not make any structural changes. For your own safety, please
use original spare parts only. These can be sourced from HUDORA. If parts
become damaged or if sharp edges or corners should develop, the product may
not be used any more. If in any doubt, please contact our service team (http://
www.hudora.de/). Store the product in a safe place where it is protected from
the elements, cannot be damaged, and cannot injure anyone.
Replace damaged or worn assembly parts in order to ensure the safety of your
scooter.
All images are examples of the design.
wHEEL CHANGE
Replacement wheels are available as accessories from http://www.hudora.de/
and should be replaced when they get worn down. To change the wheels, loosen
the axle fitting with two Allen keys and remove the wheels from the axle. A scre-
wdriver or Allen key can be used to push the bearings out of the wheel in order
to use them again in the new wheels. However, it is usually advisable to change
the bearings when the wheels are being changed. Put the bearings into the new
wheel with the spacer sleeve and mount them to the frame with the axle screws.
Make sure that the axle has been screwed on tightly before starting again!
BEARINGS
Your scooter is equipped with precision ball bearings which were filled with
lubrication at high pressure during manufacture. For this reason, the wheels can
only run easily and quickly when there is a load on the scooter. The bearings
are maintenance free. If a bearing should fail, it should be completely replaced.
Bearings are available as accessories at http://www.hudora.de/.
DISPOSaL aDvICE
At the end of the product's life, please dispose of it at an appropriate collection
point provided in your area. Local waste management companies will be able to
answer your questions on this.
IMPORTANT NOTE ON DISPOSING
OF BATTERIES AND ACCUMULATORS
According to German battery legislation, all consumers are obliged
to return all used and empty batteries and accumulators. It is
forbidden to dispose of them via the house waste. Old batteries and
accumulators can be handed in free of charge at municipal public
collection points and everywhere where batteries and accumulators
of the relevant type are sold.
SERvICE
We make every effort to deliver faultless products. If faults do arise however, we
put just as much effort into rectifying them. Therefore, you can find numerous
information on the product, replacement parts, solutions to problems and lost
assembly manuals at http://www.hudora.de.
6/16

Publicidad

Tabla de contenido
loading

Tabla de contenido