Troubleshooting Guide - Renfert Top spin Instrucciones Para El Servicio

12. Accessories
5010-0001 1 stepped drill bit
(see drawing 1)
367-0000 3 Smart-Pin drill bits
(see drawing 2)
Drawing 1
Drawing 2

13. Troubleshooting Guide

Fault
• The unit does
not switch on.
• The drill holes
are too big or
not round.
• The drilling is
not effective.
Cause
• The electricity supply
is not properly con-
nected.
• The electrical safety
device is faulty.
• The drill bit is damaged
or worn.
• The drill jig is not tight
enough.
• Chuck dirty.
• The drill bit is worn.
• Check the electricity supply.
• Check the electrical safety device.
• Replace the drill bits, clean the
drill jig.
• Tighten the jig by hand.
• Cleaning chuck.
• Replace the drill bit.
- 5 -
Remedy
Subject to modification.
EN