Statement 1030-Equipment Installation; Statement 1031-Eu Public Network Port; Statement 1032-Lifting The Chassis; Statement 1034-Backplane Voltage - Cisco Catalyst 9400 Serie Manual Del Usuario

Regulatory Compliance and Safety Information Regulatory Compliance & Safety Information for Cisco Catalyst 9400 Series Switches
Statement 1029 Blank Faceplates and Cover Panels
Warning
Blank faceplates and cover panels serve three important functions: they prevent exposure to
hazardous voltages and currents inside the chassis; they contain electromagnetic interference
(EMI) that might disrupt other equipment; and they direct the flow of cooling air through the
chassis. Do not operate the system unless all cards, faceplates, front covers, and rear covers are
in place.
Statement 1030 Equipment Installation
Warning Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Statement 1031 EU Public Network Port
Warning If the symbol of suitability with an overlaid cross appears above a port, you must not connect
the port to a public network that follows the European Union standards. Connecting the port to
this type of public network can cause severe personal injury or can damage the unit.
Statement 1032 Lifting the Chassis
Warning
To prevent personal injury or damage to the chassis, never attempt to lift or tilt the chassis using
the handles on modules (such as power supplies, fans, or cards); these types of handles are not
designed to support the weight of the unit.
Statement 1034 Backplane Voltage
Warning
Hazardous voltage or energy is present on the backplane when the system is operating. Use
caution when servicing.
Regulatory Compliance and Safety Information Regulatory Compliance & Safety Information for Cisco Catalyst 9400
Series Switches
9