Cisco Catalyst 9400 Serie Manual Del Usuario página 8

Regulatory Compliance and Safety Information Regulatory Compliance & Safety Information for Cisco Catalyst 9400 Series Switches
• Statement 1030-Equipment Installation, on page 9
• Statement 1031-EU Public Network Port, on page 9
• Statement 1032-Lifting the Chassis, on page 9
• Statement 1034-Backplane Voltage, on page 9
• Statement 1036-Telephone Jacks in Wet Locations, on page 10
• Statement 1037-Uninsulated Wires or Terminals, on page 10
• Statement 1040-Product Disposal, on page 10
• Statement 1041-Disconnecting Telephone-Network Cables, on page 10
• Statement 1045-Short-Circuit Protection, on page 10
• Statement 1046-Installing or Replacing the Unit, on page 11
• Statement 1047-Overheating Prevention, on page 11
• Statement 1051-Laser Radiation, on page 11
• Statement 1053-Class 1M Laser Radiation, on page 11
• Statement 1055-Class I and Class 1M Laser, on page 11
• Statement 1056-Unterminated Fiber Cable, on page 12
• Statement 1071-Warning Definition, on page 12
• Statement 1073-No User-Serviceable Parts, on page 12
• Statement 1074-Comply with Local and National Electrical Codes, on page 13
• Statement 2017-Class A Notice for FCC, on page 13
• Statement 2021-Class A Notice for Canada, on page 13
• Statement 3015-CS-03 Certification for Canada, on page 13
• Statement 3023-Equipment That Complies With 47 CFR Part 68, on page 13
• Statement 7001-ESD Mitigation, on page 14
• Statement 7002-Intra-Building Lightning Surge (For Shielded Cables), on page 14
• Statement 7003-Telcordia GR-1089 NEBS Standard for Electromagnetic Compatibility and Safety, on
page 14
• Statement 7004-Special Accessories, on page 14
• Statement 7005-Intrabuilding Lightning Surge and AC Power Fault, on page 15
• Statement 7012-Equipment Interfacing with AC Power Ports, on page 15
• Statement 7013-Equipment Bonding Networks CBN, on page 15
• Statement 7015-Equipment Bonding and Grounding (Required when thread-forming screws are utilized
to bond equipment to its mounting metalwork), on page 15
• Statement 7016-Battery Return Conductor, on page 15
• Statement 7017-Minimum Steady State DC Input Voltage, on page 16
• Statement 8008-Declaration of Conformity Statements Related to This Product, on page 16
• Statement 8015-Installation Location Network Telecommunications Facilities, on page 16
• Statement 8016-Installation Location Where the NEC Applies, on page 16
This document uses the following conventions:
Note Means reader be careful. In this situation, you might perform an action that could result in equipment damage
or loss of data.
Regulatory Compliance and Safety Information Regulatory Compliance & Safety Information for Cisco Catalyst 9400
Series Switches
2