INDUSTEX VIBRO 10000 Manual De Instrucciones página 5

Make sure the machine is in the O position (OFF).
1 - Lay the main unit (Nº1) on an even surface
2 - Take wire Nº 2 and pass it down the middle of the support tube Nº 3. Please pay attention to have the
larger connector at the top. With some cello tape (not supplied) tape the larger connector of the wire Nº 2
onto the main support tube Nº 3. Please see the photo below
3 - When you assemble the main support tube, make sure the wires remain connected.
4 - Connect the bottom connector of wire Nº 2 with the wire in the main unit. Please see the photo. Make
sure the wires remain connected.
5 - Now slot the main support tube Nº 3 into the main unit Nº 1.
- Please see photo below
6 - Take screws Nº 4 and washers Nº 5 and put together.