INDUSTEX VIBRO 10000 Manual De Instrucciones página 6

7 - Please use tool A. At the bottom of the main suport tube Nº 3 use the screws Nº 4 and washers Nº 5 to
attach the main suport tube Nº 3 and the main unit Nº 1.
The photograph below shows how the main suport tube should look like when connected and assembled.
8 - Now take the 2 bottom suport bars no 6 and place into the main unit no 1 Please make sure the top of the
bottom suport bars no 6 are angled away from the main unit.
9 - Now take screws no 7 and washers no 8 and put together.
10 - Take tool B and use screws 7 and washers 8 to secure the bottom suport bars 6 to the main unit 1. This
should be done at the bottom of the main unit no 1.
Take the BMI suport bars Nº 9 and place on top of the bottom suport bars Nº 6. Pay attention that the top
bars of the BMI suport bars Nº 9 fit into the main suport tube Nº 3.
11 - Please use the Tool B and take the big screws Nº 10 and secure the BMI suport bars Nº 9 to the main
suport unit.
- PHOTO NOTE – Please pay attention to keep all of the 3 wires outside of the suport tube Nº 3.
12 - Next please use tool B and the small screws Nº 11 to secure the BMI suport bars Nº 9 to the bottom
suport bars Nº 6.