INDUSTEX VIBRO 10000 Manual De Instrucciones página 7

13 - Now connect the wires of the control panel Nº 12 to the wires of the main support tube Nº 3. NOTE – for
the 2 BMI red wires it does not matter which way around they are. When you hear a clicking sound, it means
the panel is attached.
14 - Place the control panel Nº 12 onto the main support tube Nº 3 and feed the wires inside the main support
tube Nº 3.
15 - Now using screws Nº 13 at the bottom side of the control panel Nº 12 there are 3 holes. Use tool B to
secure the control panel Nº 12 to the main support tube Nº3.
16 - Now connect plug Nº14 to main unit Nº1 and connect to an electricity supply.
- Well done you are now ready to use the Vibro 10 000.