LUND Genesis Guia De Inicio Rapido página 2

Contents
Hardware:
Everything comes pre-assembled. No hardware or tools are needed for this installation. The Front & Rear Clamps are the
main moving compenents. Please be sure you have 2 of each attached to the cover before you begin your installation.
Front Slide-Clamp Mechanism
Installation Steps
Center the cover on the front end of
the bed and the side rails, and begin to
tighten the clamps until they are snug.
Do not tighten completely. Repeat on
the opposite side of the truck.
Tighten
"Counter Clockwise"
Adjust front slide-clamp
to proper height.
Unclip the snap clips located in the front
of the cover allowing the cover to unfold.
The cover has retaining straps with quick-
release buckles to keep it from being
damaged when bulk hauling or when it is
not on the vehicle. Failure to install the
front slide-clamps properly will result
in cover fly-off which is not covered by
Manufacturer's Warranty.
Clamp
Thumb Nut
Rear Slide EZ-Clamp Mechanism
NOTE: Actual application may vary slightly from drawings.
Loosen
"Clockwise"
Slide front clamp holder
under truck bed rail.
EZ Cam Clamp
Handle Lever
Page 2 of 4
Rotate thumb nut to tighten
clamp enough (not too tight).