Specific Safety Rules - Porter Cable PCE360 Manual De Instrucciones

tool may result in personal injury.
e) Do not overreach. Keep proper
footing and balance at all times.
This enables better control of the
power tool in unexpected situations.
f) Dress properly. Do not wear loose
clothing or jewelry. Keep your
hair, clothing and gloves away
from moving parts. Loose clothes,
jewelry or long hair can be caught in
moving parts.
g) If devices are provided for the
connection of dust extraction and
collection facilities, ensure these
are connected and properly used.
Use of dust collection can reduce
dust-related hazards.
4) POWER TOOL USE AND CARE
a) Do not force the power tool. Use
the correct power tool for your
application. The correct power tool
will do the job better and safer at the
rate for which it was designed.
b) Do not use the power tool if the
switch does not turn it on and
off. Any power tool that cannot
be controlled with the switch is
dangerous and must be repaired.
c) Disconnect the plug from the
power source and/or the battery
pack from the power tool before
making any adjustments,
changing accessories, or storing
power tools. Such preventive safety
measures reduce the risk of starting
the power tool accidentally.
d) Store idle power tools out of
the reach of children and do not
allow persons unfamiliar with the
power tool or these instructions
to operate the power tool. Power
tools are dangerous in the hands of
untrained users.
e) Maintain power tools. Check
for misalignment or binding of
moving parts, breakage of parts
and any other condition that may
affect the power tool's operation.
If damaged, have the power
tool repaired before use. Many
accidents are caused by poorly
maintained power tools.
f) Keep cutting tools sharp and clean.
Properly maintained cutting tools with
sharp cutting edges are less likely to
bind and are easier to control.
g) Use the power tool, accessories
and tool bits, etc. in accordance
with these instructions, taking into
account the working conditions
and the work to be performed.
Use of the power tool for operations
different from those intended could
result in a hazardous situation.
5) SERVICE
a) Have your power tool serviced by
a qualified repair person using
only identical replacement parts.
This will ensure that the safety of the
power tool is maintained.

Specific Safety Rules

• Hold power tool by insulated gripping
surfaces, when performing an
operation where the cutting accessory
may contact hidden wiring or its own
cord. Cutting accessory contacting a
"live" wire may make exposed metal
parts of the power tool "live" and could
give the operator an electric shock.
• Use clamps or another practical way
to secure and support the work piece
to a stable platform. Holding the work
by hand or against your body leaves it
unstable and may lead to loss of control.
• Hold saw firmly with both hands for
all cutting operations. During cutting
operations, the blade may suddenly
bind in the work and may cause the saw
to kickback towards the operator.
• Keep hands away from cutting area.
Never reach underneath the material
for any reason. Hold front of saw by
grasping the contoured gripping area.
Do not insert fingers or thumb into the
vicinity of the reciprocating blade and
blade clamp. Do not stabilize the saw by
gripping the shoe.
• Keep blades sharp. Dull blades may
cause the saw to swerve or stall under
pressure.
• Use extra caution when cutting
overhead and pay particular attention
to overhead wires, gas or water lines,
which may be hidden from view.
Anticipate the path of falling branches
and debris ahead of time.
• When cutting pipe or conduit ensure
that they are free from water, electrical
wiring, etc.
• Do not touch the workpiece or the
blade immediately after operating the
tool. They can become very hot.
WARNING:
glasses. Everyday eyeglasses are NOT
safety glasses. Also use face or dust
mask if cutting operation is dusty.
ALWAYS WEAR CERTIFIED SAFETY
EQUIPMENT:
• ANSI Z87.1 eye protection (CAN/CSA
Z94.3),
3
ALWAYS use safety