Movement R5i Manual Del Propietário página 100

MAINTENANCE
COMMON FAULT AND MAINTENANCE
Problem
and Code
A - No energy
B - Security key not inserted
C - Signal cut in the electronic system
The treadmill
D - Treadmill does not start
does not work
E - Blown fuse
F - Transformer has not been
installedcorrectly or is defective
G - Electrical circuit interrupted
The running
A - The running belt is not well lubricated
belt does not
B - Very tight running belt
move correctly
A - The running belt is slack
The
running belt
is slipping
B - The motor belt is tooslack
A - The security key has fallen
The treadmill
stopped
suddenly
B - Electronic system problem
A - Defective keys
Malfunction
of the keys
B - Key does not work
E1
Loose or defective connection wire
A - Motor cable or motorbroken
E2
B - Poor connection between the
motor wires and the controller or
bad controller
A -Connection wire loose or
withdefective or defective controller
E3
B - Evil speed sensorinstalled
or defective
Cause
46
Solution
Plug in
Insert the security keycorrectly
Check the control panel and cable
of signal
Verify that the on and off buttonis
in the correct '' ON '' position
Change the fuse
Install the transformer correctlyor
exchange it
Check the connection wire and
terminalconnecting wire and
connectcorrectly.
Apply lubricant to the running belt
Adjust the running belt tightness
Adjust the running belt tightness
Adjust the engine belt
Insert the power key correctlysafety
Request technical assistance
Changes the keys
Change keyboard and wiring. Swap
plate PCB and computer.
Connect correctly or change the wire
between the console and the controller.
Change the engine
Check and reconnect the cablesor
change the controller
Connect the wiring to theengine or
change the controller
Install the sensor correctly speed or
change the speed sensor velocity