Movement R5i Manual Del Propietário página 101

Ocultar thumbs Ver también para R5i:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

MAINTENANCE
CONSOLE
ITEM
A - The induction wire of the slope
is not placedcorrectly
B - The AC wire of the tilt motoris
E4
not placed correctly
C: Connect the loose wire or
defect of the tilt motor.
D: Defective controller
A - Over load and some part is
blocked carrying a current
excessive engine
E5
B - Defective motor and controller
C - Power and voltage are not
incompliance or are too low
A - Voltage below 50V of voltage
correct
E6
B - Defective controller
C - Engine connection wire badly
connected
A - Pulsation sensor wire barely
connected or defective
No heartbeat
B - Defective console circuit
A - The screw on the PCB board is
Display
loose
console not
stay on
B - Defective console
FOUND AN AUTHORIZED POINT
If you identify any problem in your equipment, contact the Authorized Point and
request a technical visit.
Any doubt, critic or suggestion can be feita na nossa Central de Atendimento ao
Consumidor, telephone 0800 772 4080.Never try to exchange any item or any
modification of the equipment, on pain of losing the guarantee.To find the nearest
Authorized Point, access the site http://movement.com.br/assistencia-tecnicaWhen
entering the contact as an Authorized Point, it will be necessary to present a copy of the
fiscal note (for warranty services) and inform the equipment serial number.
CAUSE
47
MAINTENANCE
Place the induction wire correctly
The AC wire corresponds to the logo
on the controller
Change the connecting wire or
the Incline
Change the controller
Adjust the treadmill and restart
Change engine and controller
Perform a new voltage test
Check the voltage at the outlet and
carry outnew test with the correct voltage
Change controller
Connect motor wire correctly
Connect sensor wire correctlyor
change the wire
Change the console
Tighten the screw securely
Switch console

Publicidad

Tabla de contenido
loading

Tabla de contenido