Peavey Ecoustic E110 Manual De Operación página 20

Session 300 Rear Panel
MASTER DI GROUND LIFT
5
Engaging this switch will disconnect the ground connection from pin 1 on the DI output XLR
Jack. Usually this should be left in the "out" position; however, there may be certain situations when connect-
ing from the DI jack to another device that a hum is produced due to a ground loop. If this happens, then press-
ing the ground lift switch in should eliminate the problem.
XLR DI OUTPUT
6
The XLR jack is a low-impedance, balanced output for connecting directly to a stage box or mixer
for live or studio use.
1/4" LINE OUTPUT
7
Direct line-level balanced 1/4" output for connecting directly to a stage box or mixer for live or studio use.
STEREO LINK OUT JACK
8
Connecting this to the Power Amp Input on another Session 300 (5) will complete the stereo image in the ef-
fects section. In this example, this amplifier would be the first amplifier and the front-panel controls would be
active.
CHANNEL III RCA INPUT JACKS
9
RCA type input jacks for connecting outboard gear such as CD players, MP3 players or drum machines to Chan-
nel III of the Session 300.
TRS 1/4" LINE OUT FOR CHANNELS I AND II
10
Direct line level balanced 1/4" output for connecting either channel directly to a stage box or mixer for live or
studio use. This output is prior to the digital effects section, so the front-of-house engineer can have a pure
instrument signal.
XLR DIRECT INTERFACE FOR CHANNELS I AND II
11
Low-impedance, balanced output for connecting either channel directly to a stage box or mixer for live or studio
use. This output is prior to the digital effects section so the front-of-house engineer can have a pure instrument
signal.
DI OUTPUT EQ PRE/POST SWITCH FOR CHANNELS I AND II
12
Switches the channel-specific DI outputs from pre or post EQ source.
DI OUTPUT GROUND LIFT FOR CHANNELS I AND II
13
Pressing this switch "in" will disconnect the ground connection from pin 1 on the DI output XLR Jack. Usually
this should be left in the "out" position; however, there may be certain situations when connecting from the DI
jack to another device that a hum is produced due to a ground loop. If this happens, then pressing the Ground
Lift Switch should eliminate the problem.
PRE-EQ EFFECTS LOOP SEND FOR CHANNELS I AND II
14
For sending the signal to an outboard effects processor(s). The Session 300 is equipped with separate effects
loops for channels 1 and 2. This effects send is pre-eq.
PRE-EQ EFFECTS LOOP RETURN FOR CHANNELS I AND II
15
The signal return from your outboard effects processor(s). This effects return is pre-eq.
TUNER OUTPUT
16
Connect this to your outboard tuner. When the Tuner/Mute switch is engaged, this output remains active for
quiet tuning. This output could also be used as an auxiliary line output.
20