Peavey Ecoustic E110 Manual De Operación página 21

Digital Effects Section
CHANNEL SWITCH
1
Switches between the Channel I and Channel II effects presets. This feature is footswitchable using the
optional Ecoustic Series Foot Controller. This button also switches between the Channel I and II preamps in
Channel Switch mode.
PARAMETER EDIT MODE SWITCH
2
Toggles between Normal mode and Parameter Edit mode. When in Normal mode, the encoders (5, 6, 7) are
the level controls for the effects, and the labels "chorus", "delay" and "reverb" are lit. When in Parameter
Edit mode, the encoders' LEDs change to reflect the current settings of the parameters, and serve to adjust
the parameters as you turn them, and "rate", "feedback" and "decay" are lit. Pressing this switch again
returns the effects section back to normal mode.
TAP TEMPO CONTROL
3
Tapping this switch sets the delay time. The delay time is set to the tempo you tap on this button.
BYPASS SWITCH
4
Pressing this switch bypasses the digital effects.
CHORUS ENCODER
5
In normal operation mode, this controls the level of the Chorus. You will notice that the "chorus" label is lit in
normal mode. In Parameter Edit mode, this controls the rate of the chorus effect and you will notice that the
"rate" label is lit.
DELAY ENCODER
6
In normal operation mode, this controls the level of the delay. You will notice that the "delay" label is lit in
normal mode. In Parameter Edit mode, this controls the feedback of the delay effect and you will notice that
the "feedback" label is lit.
REVERB ENCODER
7
In normal operation, this controls the level of the reverb. You will notice that the "reverb" label is lit in normal
mode. In Parameter Edit mode, this controls the decay of the reverb effect and you will notice that the "de-
cay" label is lit.
1
2
3
4
21
5
6
7